Thingiverse
Ramps Mount for Mendel
door rullmann
1
Downloads
3
Likes
0
Makes
This bracket will allow you to mount the Ramps electronics on the left rear of a Mendel.
The bracket snaps onto the threaded rods and then zip ties are used to hold it in place.
Pockets for nuts allow for the ramps board to be assembled to the bracket with screws.
3x 3mm filament holes are provided to support wire harness routing.
Zip tie holes are included along the vertical sides to allow for wire harness retention.
The bracket snaps onto the threaded rods and then zip ties are used to hold it in place.
Pockets for nuts allow for the ramps board to be assembled to the bracket with screws.
3x 3mm filament holes are provided to support wire harness routing.
Zip tie holes are included along the vertical sides to allow for wire harness retention.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!