Raspberry house for AM8

thanks to CPT_Spekkie and Adinin for helping me with feedback :)

i added the .f3d file for thoose willing to make personal changes. IF you make something and put on thingiverse please write my name as original author :)

please always read version reports and use appropriate versions

made this case for a raspberry 3 for AM8.
there is access to audio, HDMI, power and SD card and GPIO against the extruded frame.

there is also an cable duct for use between rasp and electronic case.


needs following:

1pc thumbscrev M4 (self tap)
3pc M5 screws 10mm (4pc if you decide to use the duct)
4pc 2.5mm screws and nuts

keep in mind that the screws for the side to the frame needs a smaller skull sinces the GPIO ports may be in the way.(should be fixed in V5)

printed with supports, my rasp fitted perfectly after i went over the contact holes quickly with a knife to smooth edges.

will be work-in-progress till someone else printed and gave it "ok"

2017-06-19
Version fix: