Raspberry Pi 1B with PiFace casing

This case should fit the Raspberry Pi model 1B, with the PiFace (element 14) that came with 2 relays.
The case have the Raspberrypi logo on top, and there are holes on the top for the 4 switches, and 8 holes(tunnels) that aligns to each of the output leds.
The pin included should be printed in 4 copies. These are for outside access to the swicthes on the PiFace. These are very tight fitted, so them must be squezed through the lid and will not fall out. If they are too tight you can use some sandpaper or similar to make an exact fit.
The original case design from paulgeneres was made for using rubber bands around the case. Rubber bands can still be used, or you can print 4 copies of the Clip included to hold the parts together.