Thingiverse
Raspberry Pi 2/3 NES case
von Bocklar
708
Downloads
566
Likes
22
Makes
I didn't like the fit and finish on other raspberry pi NES style cases, so I made my own! It took several iterations before I was happy with it, and I think it's good enough to share now! While I didn't use anyone else's designs for the case and made it from scratch in autodesk inventor 2016, even though it looks like some others on here.
It uses a peg system to align the top and bottom halves and to keep the Pi in place. There are no clips used and you don't need screws to keep it together. It just uses the tightness of the dimensions to stay together but can easily be pried apart with a small screwdriver to get to the Pi board. That being said, depending on how dimensionally accurate your printer is, you may have to sand down the pegs, enlarge the holes, etc. to get it to fit.
It uses a peg system to align the top and bottom halves and to keep the Pi in place. There are no clips used and you don't need screws to keep it together. It just uses the tightness of the dimensions to stay together but can easily be pried apart with a small screwdriver to get to the Pi board. That being said, depending on how dimensionally accurate your printer is, you may have to sand down the pegs, enlarge the holes, etc. to get it to fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
