Thingiverse
Raspberry Pi 3 + 2ch relay case remix
von melrhombus
7
Downloads
6
Likes
0
Makes
Needed a case for pi and 2ch relay to control some fans/leds in an enclosure.
I took the original and added mount pegs for relay and posts for terminal blocks
v1 (pictured) had 5 post and block was a tad too close to the divider so I removed one post and centered them.
History:
1.0
- Bottom case
2.0
- Added cover with holes for gpio/camera/30mm fan (M3)
I took the original and added mount pegs for relay and posts for terminal blocks
v1 (pictured) had 5 post and block was a tad too close to the divider so I removed one post and centered them.
History:
1.0
- Bottom case
2.0
- Added cover with holes for gpio/camera/30mm fan (M3)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
