Thingiverse
Raspberry Pi 3/4 DIN Mount
por jsaintrocc
38
Descargas
31
Likes
0
Makes
Based on the ingenious design by [jwags55](https://www.thingiverse.com/jwags55). This remix is designed to fit more modern Raspberry Pi's (3 and later). The tolerances were tightened up so it should be a tight fit on 35mm DIN Rails and hold the board securely. Also this mounts the boards slightly closer to the rails. *Note: It's really easy for me to tune the parameters so if it's too loose/tight let me know in the comments and I can make some adjustments.*
**Features**
* Snap fits to DIN and Board (No screws needed)
* Works with PLA
* Low profile
* No tools required
* Easy and fast to print (No supports)
**Printing Tips**
* Use 4 perimeters
* 4 Top/Bottom layers
* 20% Gyroid infill
* 20% Gyroid infill
**Features**
* Snap fits to DIN and Board (No screws needed)
* Works with PLA
* Low profile
* No tools required
* Easy and fast to print (No supports)
**Printing Tips**
* Use 4 perimeters
* 4 Top/Bottom layers
* 20% Gyroid infill
* 20% Gyroid infill
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
