Thingiverse
Electronics
Go to Model
Raspberry Pi 3.5" piTFT
72
Downloads
63
Likes
1
Makes
Remixed from [this thing](https://www.thingiverse.com/thing:3602609)
Inset 3.5" adafruit 2441 piTFT with risers printed.
I print the base vertical with a brim and supports everywhere.
Warning!!
the standoffs for the pitft are a bit short, put in a washer or couple tiny o-rings between the standoff and the pitft screen. the pitft may crack on tightening if you don't put something in that space there was a little bugger of material on the backside that upon tightening the screen cracked on me
Inset 3.5" adafruit 2441 piTFT with risers printed.
I print the base vertical with a brim and supports everywhere.
Warning!!
the standoffs for the pitft are a bit short, put in a washer or couple tiny o-rings between the standoff and the pitft screen. the pitft may crack on tightening if you don't put something in that space there was a little bugger of material on the backside that upon tightening the screen cracked on me
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
