Raspberry Pi 3 and camera mount for Hypercube using motionEyes

I wanted to mount a camera on my Hypercube so I can watch the progress of prints remotely, so I remixed


https://www.thingiverse.com/thing:2724200
Raspberry Pi 3 Case for 2020 extrusions by Greg191134

and

https://www.thingiverse.com/thing:1718628
Adjustable/Rotating Mount for Raspberry Pi Camera V2 by theodroid

to make a Raspberry Pi3 case to mount on a 3030 extrusion with an integrated mount for the Raspberry Pi camera.

Using the motionEye image I downloaded here: https://github.com/ccrisan/motioneyeos/releases/tag/nightly-dev , I had an IP camera set up and working in 15 minutes.

I modified the camera front cover with a square opening for the lens, as the original one ha a round opening and a tab at the top to support the camera circuit board properly in the case..

I added an extension to the top case mount with tabs to attach the camera arm.

I am poweringthe Pi with a 12 volt to 5 volt converter with a microUSB plug from the power supply on my Hypercub