Thingiverse
Raspberry pi 3 bumper case
von maxpulse
7
Downloads
9
Likes
0
Makes
This is Raspberry pi bumper case.
Two designs are almost same, but thickness is different.
There are four 2.5mm screw holes without thread.
This requires a lot of supporters because print at once. :)
Two designs are almost same, but thickness is different.
There are four 2.5mm screw holes without thread.
This requires a lot of supporters because print at once. :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
