Raspberry Pi 3 Case (Remix)

This is a remix of http://www.thingiverse.com/thing:1043432 by Davideraffo.
Using a Raspbrry Pi 3 with the original case-design, swapping out the Micro-SD-Card was a pain. So i used Tinkercad customizing the case for the use with a Pi 3.
I also widened a vent-hole to add a switch to easily turn on the Pi (or to reset it).
The switch i used is this: https://www.conrad.de/de/drucktaster-12-vdc-005-a-1-x-aus-ein-diptronics-dtsm-66n-v-b-tastend-1-st-707570.html
To mount the switch i used a M3x12 screw.

[quote]...
It is designed to encase a raspberry PI ... and a cooling fan 40x40x10 5V.
To complete the assembly I used:

N° 3 screws M4 x 20 with 3 M4 nuts (for the two cases)
N° 4 Screws M3 x 16 (that I cutted to 13) with 4 M3 Nuts (for the colling fan)
N° 4 Screws M2 x 12 (that I cutted to 8) with 4 M2 Nut (for the Raspberry board)
...[/quote]

You might need to use a ballpen or something other pointy to press the switch.