Raspberry Pi 3 Fan Case

11-29-17 updates. More fine tuning of the files and also added a lower case with no tabs

I thought would share as this is a case with a fan mount and a mesh type top.

Stl file will show a solid top but here is how you get the mesh top.

In your slicer software select the following

-Infill 30%
-shell thickness at least .8 but you can go higher if you like
-bottom/top thickness 0

I designed this around 3mm bolts so i had to open the mounting holes on the Pi3 slightly

The fan was left over from an RC heli so i don't know what size fan it would be considered Hole spacing is 32.5mm in all directions

Holes go all the way through the top to get the software to build some solid material around the bolt standoffs. I didn't do this on the first one i printed and the standoff pulled off.

Updated the lid STL to fill voids around power plug, HDMI, 3.5 jack 11/29/17