Thingiverse
Raspberry Pi 3 Screwless Mount
door MrPeter
61
Downloads
30
Likes
2
Makes
I couldn't find a minimal screwless frame for my Raspberry Pi 3 so I created my own.
I've designed the pins being slightly wider at the top to hold the Raspberry Pi in place. This worked well on my print. Please test your own prints to make sure the Raspberry Pi is secure.
The dip under the SD card holder is 0.4mm thick. I printed at 0.2mm layer height or less so I had at least 2 layers there.
It took around 25 minutes to print.
I've designed the pins being slightly wider at the top to hold the Raspberry Pi in place. This worked well on my print. Please test your own prints to make sure the Raspberry Pi is secure.
The dip under the SD card holder is 0.4mm thick. I printed at 0.2mm layer height or less so I had at least 2 layers there.
It took around 25 minutes to print.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
