Thingiverse
Raspberry Pi 4 and Relay Case - 3D Printer Lighting
by Maker-Mike
2
Downloads
1
Likes
0
Makes
Case to hold Raspberry Pi 4 and a 4 relay board.
I used it to hold my printers Raspberry Pi and the relay board, to power an enclosure LED light switched on/off by Octolight (https://plugins.octoprint.org/plugins/octolight)
Full assembly instructions here
The case is held together by 4 screws (M3x6mm self tapping). There's 3 screw mount points on the sides to hang on the wall.
No supports required.
Update Nov 2025: Added a 25mm deeper version of the top for more space inside.
I used it to hold my printers Raspberry Pi and the relay board, to power an enclosure LED light switched on/off by Octolight (https://plugins.octoprint.org/plugins/octolight)
Full assembly instructions here
The case is held together by 4 screws (M3x6mm self tapping). There's 3 screw mount points on the sides to hang on the wall.
No supports required.
Update Nov 2025: Added a 25mm deeper version of the top for more space inside.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
