Raspberry Pi 4 case - Corrected

There was an error in the base plate with the fixings, this has now been corrected and uploaded along with new vented case.

Raspberry PI 4 case. You can't help but notice how hot the Pi4 gets, just adding a Noctua 40mm 5v fan makes a massive difference. 20c drop was noticed while running a stress test.
I made a little case to hold the fan and protect the Pi 4.

There are 2 versions for top and bottom and both interchangeable.
Difference between tops are one includes a slot for the camera cable and the other has the fan more centralised.

The honeycombed case was a bit of an experiment to see if this would hinder or aid cooling. It didn't help and added about 5degrees on the stress test. I included this as its more a personal preference and I think it looked better.

Case, both are the same except for the mounting lugs.

I printed these with 20% infill and a .3mm layer height.

To keep the top and Pi4 fixing simple, I have created two holes in the top plate which screw