Thingiverse
Raspberry Pi 4 Case
by kaladin
69
Downloads
50
Likes
2
Makes
Yet another Raspberry Pi 4 Case.
Wanted to keep it as small and simple as possible.
Bottom part has two versions, one with additional rails to fit into standard Aluminium extrusions. Print this with supports!
Made for inserting brass M3 Melt windings into holes of top part using a soldering iron, something like this:
https://www.amazon.com/uxcell-a16041800ux0824-Knurled-Threaded-Embedment/dp/B08GF1XCWJ
Holes are deep enought for up to 8mm long inserts
Holes in Pi 4 are a little bit too small for M3, had to file them a little bit larger to fit. You probably could use M2.5 screws.
Screw holes for optional 40mm fan are prepared, I'll probably do a version without fan hole as well.
Wanted to keep it as small and simple as possible.
Bottom part has two versions, one with additional rails to fit into standard Aluminium extrusions. Print this with supports!
Made for inserting brass M3 Melt windings into holes of top part using a soldering iron, something like this:
https://www.amazon.com/uxcell-a16041800ux0824-Knurled-Threaded-Embedment/dp/B08GF1XCWJ
Holes are deep enought for up to 8mm long inserts
Holes in Pi 4 are a little bit too small for M3, had to file them a little bit larger to fit. You probably could use M2.5 screws.
Screw holes for optional 40mm fan are prepared, I'll probably do a version without fan hole as well.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
