Thingiverse
Raspberry PI 4 Double Flirc Case Holder
por vookimedlo
6
Descargas
2
Likes
0
Makes
This holder was designed to keep my Raspberry PI 4 boards stacked firmly together while using the [FLIRC case][1].
All rear ports are accessible. However, top ports are covered except the USB-C. The reason is that I use my RPi boards in headless configuration, thus those mini-HDMIs are not needed.
The whole case consists of 2 parts:
- the main body
- the top lid
The top lid has 2 rails so it can be attached to the main body easily by sliding.
Please, use the PLA filament. There are minimal tolerances, so other materials may cause problems.
[1]: https://flirc.tv/more/raspberry-pi-4-case
All rear ports are accessible. However, top ports are covered except the USB-C. The reason is that I use my RPi boards in headless configuration, thus those mini-HDMIs are not needed.
The whole case consists of 2 parts:
- the main body
- the top lid
The top lid has 2 rails so it can be attached to the main body easily by sliding.
Please, use the PLA filament. There are minimal tolerances, so other materials may cause problems.
[1]: https://flirc.tv/more/raspberry-pi-4-case
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
