Thingiverse
Raspberry Pi 4 Honeycomb case
by JayCee09
15
Downloads
11
Likes
0
Makes
A two pieces case compatible with Raspberry Pi 4. There are two versions available:
- Upper cover cut so as to allow the passage of the RasPi Cam's ribbon cable;
- Upper cover without the cut.
In order to keep the Raspberry Pi in place, four M2.5x8 screws are recommended, but not strictly necessary.
The models are tested before the publication, but there's always room for improvements, so comments or suggestions are welcome!
- Upper cover cut so as to allow the passage of the RasPi Cam's ribbon cable;
- Upper cover without the cut.
In order to keep the Raspberry Pi in place, four M2.5x8 screws are recommended, but not strictly necessary.
The models are tested before the publication, but there's always room for improvements, so comments or suggestions are welcome!
JayCee09 also publishes on
10 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
