Thingiverse
Raspberry Pi 4 Mini Feet
por Cloaks
0
Descargas
0
Likes
0
Makes
# Overview
I am not a fan of letting my raspberry pi sit on my desk without any raisers, standoffs, or case. While cases can be nice, this solution provides a nice and **simple** set of standoffs that does the job. Benefit; this takes almost no time at all to print!
# Parts
Just print both the `base.stl` and `cap.stl` 4 times each and you are good to go.
# Notes
Since the `base` and `cap` fit together as a push fit, results may vary based on the quality of the calibration of your printer. The fit should require some pressure. When the base doesn't fit through the PCB holes on the raspberry pi, or the `cap` does not fit on the `base` then adjust XY scaling accordingly in your slicer.
I am not a fan of letting my raspberry pi sit on my desk without any raisers, standoffs, or case. While cases can be nice, this solution provides a nice and **simple** set of standoffs that does the job. Benefit; this takes almost no time at all to print!
# Parts
Just print both the `base.stl` and `cap.stl` 4 times each and you are good to go.
# Notes
Since the `base` and `cap` fit together as a push fit, results may vary based on the quality of the calibration of your printer. The fit should require some pressure. When the base doesn't fit through the PCB holes on the raspberry pi, or the `cap` does not fit on the `base` then adjust XY scaling accordingly in your slicer.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
