Raspberry Pi 5 and Pineberry HatDrive! Top Case

Recently I got a Raspberry Pi 5 to run some stuff in the workshop and bought the fine looking Pineberry HatDrive! Top and I needed a case for it, so I have produced some variations in the hope someone else finds them useful. As it is not obvious and to hopefully help someone, the official heat sink and fan fit between the Pi 5 and the HatDrive! Top if you fit the screw on the underside and the nut thing on top. This case has a basic and wall mountable variant. There are also different lid options available that give access to the GPIOs and also support a 25mm fan.Required Components4x M2.5 plastic inserts (M3 also work)4x M2.5x6 screws and washers for the case top (or M3x6)4x M2.5x8 screws and washers for connecting the case to the Pi/HatDriveThe following parts are optional if you are using a lid supporting a fan:25mm fan with correct plug for Raspberry Pi 54x M2 plastic inserts4x M2x16 screws and washers (length may vary due to fan size, this worked for me)PrintingThe prepared Bambu