Raspberry Pi 5 Case

Description
About

A clean and simple Raspberry Pi 5 Case. Has slots for all the ribbon cables and headers that the Pi 5 offers as well as a power button at the back. The two parts of the case snap together and can be release by pushing in the front sides and lifting up. This case was designed in OnShape.

Requirements

4x M2.5 Bolts 4x M2.5 Nuts
Raspberry Pi 5
Heat sink and Fan (optional)

Configurations

There are 2 options for the bottom half, one to have bolts go from below to above (useful for some heat sinks / HATs) and one for bolting from above with the hex nut going into the bottom of the case. There is also a regular and thin side IO cover, I would recommend using the thin one as it will most likely create a better connection on the type c with most cables.
Assembly

Before starting, remove the SD card from the pi.
Insert the power button to the case
Line up the side IO cover with the IO on the pi and insert
Then insert the pi into the bottom half