Raspberry pi adjustable camera base

This set of printings is for use with a Raspberry Pi mounted on a Prusa i3 MK3S 3D printer. It also assumes the camera is the “Arducam Raspberry Pi Camera Module V2-8 Megapixel, 1080p”. I purchased it from Amazon for $25. The stand as originally printed fits on the lower left bolt hole of the “X” axis motor but there are times when I wanted it looking down on your project rather than at the nozzle level. This mount allows for six different levels to mount the camera. I also modified the mounting arm so the ribbon cable comes out a bit higher so it won’t interfere with the back portion of the mounting system.

Use two M3x30mm bolts to attach the back plate to the “X” axis motor using the two right-hand bolt holes right through the existing plastic. Make sure it is vertical before tightening. Use an M3x10mm or M3x12mm bolt to secure the camera support bar to the base in whatever position you want. The screw hole is 2.75 mm in diameter, but if you have an M3 tap, make it small