Raspberry Pi Cam adjustable mount - Ender 3 V2

Raspberry Pi Cam (V2) mount for Ender 3 V2 with adjustable Z axis and adjustable tilt

For camera case:
- M3 x 30mm screw and nut
- I used 4 small screws to mount the PCB to the case but you could use hot glue etc

For spacers:
- M5 nut x2 (held in with super glue)
- M3 nut x2 (held in with super glue)

For sliding mount:
- M3 screw (I used 15mm length), washer & nut

For bracket:
- M3 screw x2 (I used 15mm length)
NOTE: My control panel is mounted on the opposite side which means the camera mount will not clash with the control panel. From the pictures you will see that the version I printed does not have this cut out, I added the cut out for those who have the control panel mounted in the standard position.