Thingiverse
Raspberry Pi Camera IR LED mount
door cockroach_dude
1
Downloads
1
Likes
0
Makes
This is a set of mounts for 5mm LEDs. They bolt in place of a spacer behind the Raspberry Pi camera.
For IR LEDs the the 2 and 4 mounts run on 3.3v, the 3 mount runs on 5v. Use a small resistor to pull the voltage down for the LEDs. Do not try to run 4 LEDS directly from GPIO, use a transistor if you want to switch them.
For IR LEDs the the 2 and 4 mounts run on 3.3v, the 3 mount runs on 5v. Use a small resistor to pull the voltage down for the LEDs. Do not try to run 4 LEDS directly from GPIO, use a transistor if you want to switch them.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
