Thingiverse
Raspberry Pi Camera Mount Base
von Minsis
5
Downloads
0
Likes
0
Makes
Remix of https://www.thingiverse.com/thing:247590
I wanted a flat base so I could put magnets or double sided tape to stick to side of the 3D printer. Also made a ~100mm link.
I wanted a flat base so I could put magnets or double sided tape to stick to side of the 3D printer. Also made a ~100mm link.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!