Thingiverse
Raspberry Pi camera mount for duplicator i3
por unwohlpol
7
Descargas
5
Likes
0
Makes
This is a camera mount for attaching a raspberry pi camera board onto a duplicator i3 v2.1.
The POV will follow the Z-axis and therefore gives a nice overview of your print from bottom to top.
There's one version (39) which can be attached onto the left side of the x-gantry without obstructing anything, but will decrease the x axis width if attached to the right.
If you prefer right, like I do, print the version #49 which is longer and therefore gives a better view (I've added 2 pictures that are supposed to show the POV). The downside of this version is that it's rather flimsy and prone to vibrations.
For installation you'll need 4, resp. 2 pieces of M3x10 screws. The original ones will be too short.
The POV will follow the Z-axis and therefore gives a nice overview of your print from bottom to top.
There's one version (39) which can be attached onto the left side of the x-gantry without obstructing anything, but will decrease the x axis width if attached to the right.
If you prefer right, like I do, print the version #49 which is longer and therefore gives a better view (I've added 2 pictures that are supposed to show the POV). The downside of this version is that it's rather flimsy and prone to vibrations.
For installation you'll need 4, resp. 2 pieces of M3x10 screws. The original ones will be too short.
unwohlpol también publica en
125 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
