Thingiverse
Raspberry Pi camera mounted light
von StuartF619
31
Downloads
20
Likes
0
Makes
Designed this light holder for the camera mount on https://www.thingiverse.com/thing:2842300 by hamkers.
This is large enough for a 10mm LED strip. I only had 8mm strip, so I used two short pieces of cable tie to hold the strip in.
Printing:
I printed this face down with support touching bed only.
This is large enough for a 10mm LED strip. I only had 8mm strip, so I used two short pieces of cable tie to hold the strip in.
Printing:
I printed this face down with support touching bed only.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
