Thingiverse
Raspberry Pi Camera Ribbon Cable Guide - Ender 3
door OmniMaker
58
Downloads
27
Likes
0
Makes
I wanted to use a Pi Camera instead of USB, but hated the idea of a loose ribbon cable. So to solve the problem, I created a flexible cable management for the ribbon cable. using the various parts you can cleanly route your camera cable. Each section pivots 180 degrees.
On my Ender 3, I used the excellent Pi case from
https://www.thingiverse.com/thing:3075921
and mounted it upside-down underneath the LCD display. I then glued my cable guide to the side of the case. The ribbon cable is routed between the upper and lower case pieces with no modifications required.
Hint: You can roll up quite a bit of Pi camera cable inside the case so you won't have to guess which length cable you need. I think mine is 3 meters, with most of it rolled up inside the case with a little tape to keep it from unraveling.
**Edit 1-15-2019. The above link has stopped working. I have included the files for the original PI case with slight modification for the camera cable access. There are
On my Ender 3, I used the excellent Pi case from
https://www.thingiverse.com/thing:3075921
and mounted it upside-down underneath the LCD display. I then glued my cable guide to the side of the case. The ribbon cable is routed between the upper and lower case pieces with no modifications required.
Hint: You can roll up quite a bit of Pi camera cable inside the case so you won't have to guess which length cable you need. I think mine is 3 meters, with most of it rolled up inside the case with a little tape to keep it from unraveling.
**Edit 1-15-2019. The above link has stopped working. I have included the files for the original PI case with slight modification for the camera cable access. There are
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
