Raspberry Pi Camera Wide Angle Lens Full Case

This is a quick remix from DanTexasMan. I changed the height of the housing itself so it fully covers the camera board and lens inside. Also added a simple coupler with stems (80 and 120 mm) and a weather cover. Cover and coupler should be glued on. 3/3.5 mm screws will match nicely.

Allows for horizontal and vertical adjustments. Drill hole through coupler if you need to.

I'm using this simple case with a SainSmart Wide Angle Lens (https://www.amazon.de/gp/product/B00N1YJKFS/) as surveillance module on a Raspberry Pi 4 monitoring my property.

Notes:
Printing time for each part ranges from 20-40 minutes with the settings below. For rigidity print the stems laying flat.If you need a different size of the stem, just grab your fav 3D tool and extend the vertices from one end to suite your requirements. :)