Raspberry Pi Case (80 mm fan)

Hey! I was rummaging through the old spare electronics box and I found an 80 mm fan case! I wanted to make an elegant nice looking case for my 4b that fits the fan and can power it so I got to work! Anyways, I'm proud to showcase this pretty case for any Raspberry B series 3/4/5 (I used a 4B) and I hope you find this useful. Boost MeAlways free to boost! (Won't hurt to give it a click!)Anyways, you will need extra hardware and here is the list:Raspberry pi B series4x M4 x 30mm Screws 4x Hex Nuts (that fit the M4 x 30mm Screws)80mm Case Fan 2 Dupont cables (the breadboard jumper cables)The 3d printed partsAnd lastly, 2x or 4x M2 x 10mm Self Tapping ScrewAssembly is not too complex but my steps were:Connect dupont cables to fan for later assemblyScrew down Pi to the bottom part of the caseGrab fan, organise cables With the top 3d printed part on top use the screws and hex nuts to screw the fan and part togetherSlide the parts togetherIf the tolerances on your printer are set up c