Thingiverse
Raspberry Pi Case Seals
von webgiant
0
Downloads
2
Likes
0
Makes
I really liked the Raspberry Pi 3.5" TFT case, https://www.thingiverse.com/thing:1895374, but even with the clip the case wouldn't stay closed. Tape made it harder to get open and closed for future tinkering. Glue was just not something I wanted to do.
So I created these tight fitting case seals for the case. They fit on the top and the bottom, with a hole on the bottom to allow access to the microSD card, and do not block any ports or air vents. I printed them with 100% infill for maximum strength.
So I created these tight fitting case seals for the case. They fit on the top and the bottom, with a hole on the bottom to allow access to the microSD card, and do not block any ports or air vents. I printed them with 100% infill for maximum strength.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
