Thingiverse
Raspberry Pi Endstop Plug Aligner
di BrianHanifin
147
Download
71
Likes
0
Makes
I created this helper to make sure my endstop jumpers were plugged into the correct pins on my Raspberry Pi. I use Octoprint to sense when the filament runs out. This was designed for my use, and I am sharing this in case someone else might find it useful.
The [Makerbot 1.2 style endstop](https://www.aliexpress.com/item/3D-Printer-Switch-For-Endstop-Mechanical-Limit-Switches-with-cable-for-RAMPS-1-4-CNC-3D/32770359838.html?spm=2114.13010608.0.0.SWQqwi) I got requires 3.3vdc, ground, and an I/O pin. This forces you to use Pin 1 (3.3vdc), Pin 6 (ground), and Pin 7 (GPIO 4).
There are many filament endstops cases and mounts available on Thingiverse.
I recommend you make sure the pins line up correctly before connecting the wires to your endstop. (I hooked up the pins in the wrong order once and it rebooted my Pi, I'm lucky I didn't wreck anything!)
The [Makerbot 1.2 style endstop](https://www.aliexpress.com/item/3D-Printer-Switch-For-Endstop-Mechanical-Limit-Switches-with-cable-for-RAMPS-1-4-CNC-3D/32770359838.html?spm=2114.13010608.0.0.SWQqwi) I got requires 3.3vdc, ground, and an I/O pin. This forces you to use Pin 1 (3.3vdc), Pin 6 (ground), and Pin 7 (GPIO 4).
There are many filament endstops cases and mounts available on Thingiverse.
I recommend you make sure the pins line up correctly before connecting the wires to your endstop. (I hooked up the pins in the wrong order once and it rebooted my Pi, I'm lucky I didn't wreck anything!)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
