Raspberry Pi HQ Camera stand / holder

Just a simple holder / stand for the raspberry HQ camera.

You can adjust the vertical direction using some M2,5 bolts (tilt the holder either up or down). For these holes no thread recut needed (for me).

Yo can also mount this on a tripod (1/4 inch). Unfortunately, this hole needs a recut of the thread,

You need:
- 4 M2.5 bolts / nuts to attach the camera
- 4 M2.5 bolts for vertical direction (optional)

Edit: Minor redesign (v2) because the camera mount was blocked by the backplate support.