Raspberry Pi M.2 HAT+ 2280 Adapter Bracket (Two Versions)

UPDATE: There are now two versions of this adapter, one with a riser bump thingy for use with a different M.2 screw and one without the riser bump for use with the M.2 thumbscrew included with the M.2 HAT+.

This is an adapter bracket for the official Raspberry Pi M.2 HAT+ which allows it to accept a 2280 form factor M.2 drive. All that is needed in addition to printing this bracket is a small screw that fits the M.2 screw hole and has a flat head (no bulge), as shown in the third photo (back of HAT). This is compatible with the official Raspberry Pi 5 aluminum active cooler. The only downside it that it hangs over the USB 3 ports but it's manageable.

I had to file out the hole at the end a bit using a needle file because it was a tiny bit too small. You'll likely need to do the same.

NOTE: Be careful when removing the support material! The bracket is a bit fragile because it's so thin.