Raspberry Pi Microscope Adapter Ø ~31 mm

An adjustable Raspberry Pi camera mount for a microscope, this combines one of my earlier designs (Raspberry Pi Camera Case V3), which will be included in the files. The screws/bolts and nuts used are M4.

Aligning the camera perfectly in the middle in the design was a frustrating since it's not exactly in the middle of the circuit board and the board itself isn't perfect either, then there's the possible shrinking of the printing material afterwards.. So I decided to make the camera case adjustable. It is meant to be positioned once, since once it's in place, there really is no reason to move it (read: getting it right was pain in the ***)

Once the camera position is set to middle you can still move the whole thing on the eyepiece up and down, since the height of the eyepiece adapter it allows a bit of leeway.

There is a slight oversight in the design, if the microscope eyepiece doesn't fit perfectly tightening the eyepiece screw will squeeze one end of the rails together mak