Raspberry PI Mini NAS

## Introduction
I want to make a clean looking (no cables in and out the case) small Raspberry PI NAS including 2.5" HDD Mount and internal USB->Sata.

Electrical knownlegde is required to unsolder/cut the Raspberry PI USB Connector and solder a USB->Sata adapter directly to it.

I also used a custom DC-Jack because i would like to plug in Ethernet and Power from one side.

## With FAN Edition (w_fan)
I created a slightly bigger Version of the Case foe two Reasons:
* Fit HDDs higher than 10mm
* Fit an 40mm FAN

## Case
The Raspberry PI is not easy to fit because of the Audio Jack but when its in it helds itself in position even without Screws.

## Instructions
Unsolder the right USB Mount and solder a cheap off the shelf USB->Sata adapter to it.