Thingiverse
Gadgets
Go to Model
Raspberry Pi model B+ or Pi2 model B case
198
Downloads
164
Likes
7
Makes
A free and open source case for a __Raspberry Pi model B+__ or a __Raspberry Pi 2 model B__
The original PDF file from Pi-Supply was scaled too small, it is now scaled at 100% and can be used to send to a laser cutter as it is.
I have also added the attribution text to the base of the case as required by the CC-BY-SA license.
The top of the case also features the [Ipswich Makerspace logo](http://www.ipswichmakerspace.com)
This model is made out of 3mm hard board, I think it is actually very slightly thicker than 3mm so some of the tabs were a bit tight. If made from 3mm acrylic is should all go together fine.
Revision 3 - power socket hole has been enlarged.
The original PDF file from Pi-Supply was scaled too small, it is now scaled at 100% and can be used to send to a laser cutter as it is.
I have also added the attribution text to the base of the case as required by the CC-BY-SA license.
The top of the case also features the [Ipswich Makerspace logo](http://www.ipswichmakerspace.com)
This model is made out of 3mm hard board, I think it is actually very slightly thicker than 3mm so some of the tabs were a bit tight. If made from 3mm acrylic is should all go together fine.
Revision 3 - power socket hole has been enlarged.
keithellis also publishes on
8 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
