Thingiverse
Raspberry Pi Open Wall Mount
door mintonette
25
Downloads
30
Likes
1
Makes
Simple open wall mount designed for the Raspberry Pi 3B+, Pi 4 and Pi 5. All ports and pins are accessible.
No additional hardware needed; the Pi is held in place firmly by 3 clips. The Pi 5 version has one clip in a slightly different position, however should still be compatible with the previous models.
Important note: if using the cross shaped screw holes, check your screw head is not touching (and shorting) the back of the board. I have included an 7mm clearance version to accommodate larger screw heads.
Recommend printing everything above the 3mm base at 100% concentric infill (or increase the number of perimeters/walls) to achieve the best quality mounts and clips.
No supports needed.
4mm clearance version pictured.
No additional hardware needed; the Pi is held in place firmly by 3 clips. The Pi 5 version has one clip in a slightly different position, however should still be compatible with the previous models.
Important note: if using the cross shaped screw holes, check your screw head is not touching (and shorting) the back of the board. I have included an 7mm clearance version to accommodate larger screw heads.
Recommend printing everything above the 3mm base at 100% concentric infill (or increase the number of perimeters/walls) to achieve the best quality mounts and clips.
No supports needed.
4mm clearance version pictured.
mintonette publiceert ook op
33 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
