Thingiverse
Raspberry Pi SD Card Remover
door Abitowhit
18
Downloads
11
Likes
0
Makes
Somewhat of a one trick pony but I was having difficulty inserting the micro SD into the Raspberry Pi 3 after you have connected a 7 inch touch display.
The notch on this small tool allows you to slide it onto the SD card and remove it much easier than trying to get your fingers in there, without damaging it.
It also makes it much easier to handle the SD and insert it into the pi.
Printing it in high resolution seems to work much better.
If you need to make it longer, you should be able to simply adjust that length without affecting it's ability to grab the micro SD.
Printing in black PLA also seemed to work better than the maroon PET in the image.
Hope it helps others with not so nimble fingers. :)
The notch on this small tool allows you to slide it onto the SD card and remove it much easier than trying to get your fingers in there, without damaging it.
It also makes it much easier to handle the SD and insert it into the pi.
Printing it in high resolution seems to work much better.
If you need to make it longer, you should be able to simply adjust that length without affecting it's ability to grab the micro SD.
Printing in black PLA also seemed to work better than the maroon PET in the image.
Hope it helps others with not so nimble fingers. :)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
