Raspberry Pi v2 Camera Mount for Octoprint
von hawker180
61
Downloads
41
Likes
0
Makes
Another redesign of my Camera Mount. My last one I did not like how the ribbon sat so time for a re-design
You will need the extended ribbon cable
There are two designs, one with the ribbon cutout in the side and the other where you can feed the ribbon out the bottom.
You will need the extended ribbon cable
There are two designs, one with the ribbon cutout in the side and the other where you can feed the ribbon out the bottom.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
