Raspberry Pi Zero 2W case and rotating camera stand

There are plenty of Raspberry Pi cases. I could not help myself from making my own. Nothing fancy here, it just suits my need. I wanted to attach my Raspi Zero 2W equipped with a camera module to the wooden frame of the enclosure of my printer. So you can find side pads with holes for screws to do so on the Pi case.

### You can look at the photos to get a sense of the assembly

You only need four M3x10 screws to attach the top and bottom parts together, with the Pi in the middle; it's like a sandwich. A fifth M3x10 screw will be used to attach the camera case to a ball joint.

Plenty of slits on the Pi case to make sure the board is properly ventilated.

Then there is the camera case: the board simply sits on the little pikes. The cover snaps in the case to hold the whole thing.

And then: the ball joint. The two little arms slide and grip in the rear slots of the camera case.

The jaw has a hole to hold a M3 screw with its head flush in the cavity. The jaw snaps on the b