Thingiverse
Raspberry Pi Zero v1.3 cast case
by Anathae
5
Downloads
5
Likes
0
Makes
Two piece case with integral cooling fins. Used my Raspberry Pi reference model to make this.
The two pieces are intended to be 3d printed at 101% of the as designed size, then investment cast in aluminum. The "top" piece with the fins is designed with 75% thread engagement holes for M2.5 screws. Tap these four holes. The four holes on the bottom piece should be a close fit for an M2.5 screw.
If you want to cast it in a different metal, use the appropriate multiplier.
License for commercial reproduction can be negotiated.
Comments appreciated.
The two pieces are intended to be 3d printed at 101% of the as designed size, then investment cast in aluminum. The "top" piece with the fins is designed with 75% thread engagement holes for M2.5 screws. Tap these four holes. The four holes on the bottom piece should be a close fit for an M2.5 screw.
If you want to cast it in a different metal, use the appropriate multiplier.
License for commercial reproduction can be negotiated.
Comments appreciated.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
