Thingiverse
Electronics
Go to Model
Raspberry Pi Zero W PiKVM Case
81
Downloads
50
Likes
0
Makes
Snap on case for Raspberry Pi Zero W and HDMI to CSI-2 (TC358743XBG) bridge.
The case is quite thin to speed up the print time but it does it's job at keeping the parts together. The placement of the components is due to the short ribbon cable.
Instructions for making your own PiKVM can be found here https://pikvm.org/ (I have no affiliation with the project).
When assembling the case, place the CS bridge in first, then the spacer (in the mounting holes near the center of the case) and finally the Pi Zero on top. The lid snaps on.
The case is quite thin to speed up the print time but it does it's job at keeping the parts together. The placement of the components is due to the short ribbon cable.
Instructions for making your own PiKVM can be found here https://pikvm.org/ (I have no affiliation with the project).
When assembling the case, place the CS bridge in first, then the spacer (in the mounting holes near the center of the case) and finally the Pi Zero on top. The lid snaps on.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
