MakerWorld
Electronics
Go to Model
Raspberry Pi Zero W + Raspberry Pi Camera Case
22
Downloads
11
Likes
5
Makes
REQUIRES NO HARDWAREThe case consists of 2 parts, top and bottom, requires no supports, if the camera holding pieces don't fit the camera, are to tight, just cut them off and the case will still work perfectly. There is also a square cut out above the PI processor for a radiator, as in the images. The case can fit the long camera tape, as I did, but maybe I would recommend using the shorter one to not bend the tape so much. Feel free to comment. Also published on printables: https://www.printables.com/model/1398930-raspberry-pi-zero-w-raspberry-pi-camera-slim-snap
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
