Thingiverse
Raspberry Pi Zero W TARDIS Case
by Scotty-G
175
Downloads
122
Likes
1
Makes
Inspired by Jason3030's Raspberry Pi 3 TARDIS Case (https://www.thingiverse.com/thing:2430122), I decided to try and make one for a Raspberry Pi Zero W. Scaled down to 80% before determining placement of Pi Zero card and cutting out access holes.
Printed at .1mm layer height - not the cleanest print but good enough for now.
0.2" (~5mm) standoffs were used, along with 2-56 thread countersink screws.
Didn't have any 2-56 nuts available so used spare standoffs in their place.
Printed at .1mm layer height - not the cleanest print but good enough for now.
0.2" (~5mm) standoffs were used, along with 2-56 thread countersink screws.
Didn't have any 2-56 nuts available so used spare standoffs in their place.
Scotty-G also publishes on
38 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
