Raspberry Pi3 housing for 3d-printer enclosure

This is a housing for the Raspberry Pi3 mini-computer, which is often used to manage print jobs for FDM-3d-printers, by e.g. OctoPrint.
Dedicated use is side mounting on a printer enclosure (outside).
Make sure to leave a gap where the venting holes are.

Designed for 30mm construction bars with M6 flange screws going throu the housing halves. 2 push-button switches on the front (type Weltron 604108) with a single LED-light may be used for additional functions, such as:
shut down computer (e.g. GPIO shutdown plugin for Octoprint),
switch for enclosure lighting (one of the housings venting holes may be used to run a wire in).

Use of self-tapping screws with following diameters:
fixation of computer circiut board: 2.5mm (4x)
connection of housing halves: 3.5mm (3x)
push-button circuit board: 3mm (2x)

Hope you like it

Best regards from
Bernd's Custom 3D's