Thingiverse
Raspberry Pillars
door kipdev
22
Downloads
16
Likes
0
Makes
If you just want pillar feet for your Raspberry PI (or any other electronic board with holes like Arduino etc.) and don't need a housing or a full frame bed, this might be something for you.
All 4 pillars printed at once faster than 10 minutes. The picture shows pillars printed in about 7 minutes on a Printrbot Simple Metal using ABS at 0.2mm layer height.
All 4 pillars printed at once faster than 10 minutes. The picture shows pillars printed in about 7 minutes on a Printrbot Simple Metal using ABS at 0.2mm layer height.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!