Raspberry zero TM1637 LED clock project covered in vaneer

This is a project to make a hidden LED clock. i have used a raspberry zero and a TM1637 LED display.

the code for the clock is taken from here:
https://www.instructables.com/id/Raspberry-Pi-Amateur-Radio-Digital-Clock/

the case was printed in PLA and once the raspberry pi and clock are in an glues in place [i used epoxy to set the clock in place ] the lid is glued on.

after that i purchased a think wood vanner and glue this to the outside of the box , it took a few attempts working with the vaneer but the end result is good enough.

remember to set the brightness of the LED to 7 when setting up, so it comes through the wood veneer, you can also sand the vaneer over the clock face area to make the vaneer thinner.