RAW 8 Cone Loader King Size

I made this in tinkercad cause I could not find one for King Size RAW Cones. I also created a small ejector to put at the bottom after filling the cones so it pushes the cones up a bit and allows for easy removal with your fingers.

I used a file to get rid of some PLA burrs that I didnt want falling into the herb and gave it a quick wash but be careful If you use layer height higher than 0.15mm water will make its way into the insides and you will need to dry it out by leaving it in a warm air flow area for a few hours.

This print will fit on a 120mm Z-Height bed