Thingiverse
Razor-Clamp
por razorcrow
15
Descargas
10
Likes
0
Makes
(Updated) I increased the hole size because my wife found a razor with even a bigger handle. Also, I did break one of these so I made the stem thicker.
I created this because my wife's razor's holder (suction cup style) kept falling in the shower. The other razor holders that I found to print didn't work with our shower or didn't fit her razor. I created this based off the idea of the monster headphone holder.
I printed this upside down and used a raft because the hole in the center kept lifting off my heated bed. Make sure to use supports or this print will not print properly. I also used a large infill because the clamp will break the print due to the torque the screw places on the top. If you don't put too much torque I found 60 to be fine. However, 80 to 100 was the best infill.
I created this because my wife's razor's holder (suction cup style) kept falling in the shower. The other razor holders that I found to print didn't work with our shower or didn't fit her razor. I created this based off the idea of the monster headphone holder.
I printed this upside down and used a raft because the hole in the center kept lifting off my heated bed. Make sure to use supports or this print will not print properly. I also used a large infill because the clamp will break the print due to the torque the screw places on the top. If you don't put too much torque I found 60 to be fine. However, 80 to 100 was the best infill.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
