Thingiverse
Razor Holder Rude monkey
von ARKICK
3
Downloads
4
Likes
0
Makes
-You will need any kind of glue for the monkey´s wall support
-Supports only for the hands
-It lasted 50 minutes at 50 mm/s with .4 nozzle
TEMP:
-filament at 210
-bed at 30
-3 OR 4 PERIMETER LINES RECOMMENDED
-Supports only for the hands
-It lasted 50 minutes at 50 mm/s with .4 nozzle
TEMP:
-filament at 210
-bed at 30
-3 OR 4 PERIMETER LINES RECOMMENDED
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
